Home >> Projects

Projects

{ 2 comments… read them below or add one }

1 jody 5 January 2013 at 1:23 am

not a dyi person at all, i recently walked into a hobby lobby for probably the first time in my life. i had to enter because i was chosen by an in-law to join them in a dyi project. i purchased an iron-on design and when i got home i saw there were no directions on how to transfer this onto the fabric. please help me because i have no craft skills and really don’t care to have any. it says easy application, 325 to 350 degrees F heat requirement. that is it for directions. keeping in mind i am a complete novice, how do i do this? it is a sparkly design on clear plastic. there is a white fabric also in the package. please tell me what to do.

Reply

2 Mark Richards Enterprises 24 January 2013 at 8:17 pm

Hello,
To apply an iron on you must lay the article of clothing you wish to apply it to on a flat surface, slowly peel your iron on off of its white backing (leaving you with the clear film and stones) place where you want and apply pressure with a hot iron. Pick a corner and SLOWLY peel the clear backing from the article of clothing. If you notice any stones that have not adhered lay it back down and apply pressure again. Repeat as needed until all stones are on. You may also use a heat press if you have one. If you have any other questions please feel free to contact us.

Reply

Leave a Reply